take the bolts out all the way, they screw into the pins,then push em out
How do yo get the reverse bucket off a place diverter? Is it even possible? I have taken the bolts loose but the pins don't come out thru the inside like the others, so how the f@ck do you get it off, I need to finish sand blasting it and prep it for paint. Thanx for any info.
take the bolts out all the way, they screw into the pins,then push em out
take the bolts out all the way, they screw into the pins,then push em outNegative ghost rider. My pins only come out from the outside, you can't push them into the inside of the nozzle.
what kind of place diverter do you have? I just waked out to mine pulled the bolts out and pushed the pins in one at a time, bucket is off.....
have any pics of your setup? new, used,? can you see the pins on the inside of the nozle? if not some one might have marine tex-em in?
what kind of place diverter do you have? I just waked out to mine pulled the bolts out and pushed the pins in one at a time, bucket is off.....
have any pics of your setup? new, used,? can you see the pins on the inside of the nozle? if not some one might have marine tex-em in?Confusion maybe Travis? lol, I'm talkin about the gate on the end of the nozzle, If that is what your talkin about mine do not push thru to the inside. :argue:
ok send me a pic if you can, and i'll help ya out....
casper@mycvc.net
ok send me a pic if you can, and i'll help ya out....
casper@mycvc.net10-4 I'll run down stairs and take a pic.
See what you mean! Holes don't go thru into the nozzle.
hey flea.. mine is like yours and I couldn't figure it out either... I think new bushings would keep the gate from trying to close all the time.
Here you go.
First pic looks inside the nozzle no holes for the pins to push into.
second & third pic is of the pins.