I used -8AN
I have an eliminator 210 eagle with a set back legend pump. I would like to change the water intake hose from the nasty rubber one to a nice braided hose with fittings. Can someone tell me what size to use, 8an, 10an, 12an, the hose on there does not seem to have a size on it.. Also, is a standard bulkhead fitting long enough to go through the pump and hull so I can attach hose on th other side.. Any help would be great. thanks!!!
I used -8AN
-8AN works well for me also.
You can use -8(which is most common) or -10.
-8 for me too. I gotta agree with Micheal and say 8 or 10 would be the best. Dont think I'd go smaller than -8
-8 for me too. I gotta agree with Micheal and say 8 or 10 would be the best. Dont think I'd go smaller than -8
Dumb question but I have to ask... The larger the number the smaller the hose??
the larger the number the bigger the hose.
the larger the number the bigger the hose.
Thanks Mc.
the larger the number the bigger the hose.
Yup, somebody on here has a cross reference to what the ID size is for SS lines. I've seen it but can't find it
Think of it in 1/16's
-8 = 8 - 1/16's or 1/2 inch
-10 = 10 - 1/16's or 5/8 inch
-12 = 12 - 1/16's or 3/4 inch
etc . . .
GOT IT
_____