Results 1 to 2 of 2

Thread: Hallett project cont'd

  1. #1
    Icarus prospector
    So now that the Olds is out (check the Spam section..!) and all the misc is in the dumpster, I've been able to really get an appreciation of Halletts and count my blessings that I'm only the third owner- the butchery so often seen in used boats is at a very workable minimum.
    Here's where I need your guidance. The 454/T400 is going in and I'm wondering how far down in between the stringers to install the fab'd brackets to bolt to the plates is correct. Is it a matter of leaving 1-2 inches below the pan or is there some geometry involved so the drivelines all come together with 1-2 dregrees of u joint love?
    Thanks in advance!

  2. #2
    GofastRacer
    Angle on motor and v-drive must be constant, 1-2 degrees on the driveshaft!..

Similar Threads

  1. mynew project hallett.
    By hallettman in forum Jet Boats
    Replies: 9
    Last Post: 09-03-2006, 10:25 PM
  2. Wanted :jet boat project for son's senior project!!!
    By 78 challenger in forum Parts 4 Sale
    Replies: 15
    Last Post: 08-21-2006, 01:14 PM
  3. 88 Hallett 21' Project boat
    By Hustler in forum Parts 4 Sale
    Replies: 11
    Last Post: 01-11-2006, 07:10 PM
  4. 88 Hallett 21' project
    By Hustler in forum Jet Boats
    Replies: 0
    Last Post: 01-04-2006, 10:01 AM
  5. For Sale! 1979 Hallett Sport Twin Turbo Project.
    By Ex PSI Canyon in forum V-Drives
    Replies: 9
    Last Post: 10-17-2004, 10:58 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •