A compression or a leak down test (preferrably) would tell you for sure. It is likely a head gasket, but I would test a little, before you jump into it, only to find out it was not the problem.
I found water in my oil.... So I am assuming I have blown a headgasket in my Whipple 6.2..... Any thoughts on how much it should cost to get it replaced???
A compression or a leak down test (preferrably) would tell you for sure. It is likely a head gasket, but I would test a little, before you jump into it, only to find out it was not the problem.
Thanks I did a leakdown test, have changed the oil and re-ran it once again the water was in.... did check the exhaust to, all bolts seemed tight... unfortunately I am sure it is the intake gasket or head gasket, both require about the same to replace, and must go through the intake to get to the head....