Anyone Run Aggressor Inpellers & Ultimate Wear Ring?

[FoMoCo]

Does anyone run Aggressor Bronze Impellers? I just bought a Aggressor B bronze and I was curous what RPM you guys are runnin with them? Also is anyone runnin the Ulitmate Wear ring with them? Any luck with this Combo?

[jim@pj]

FoMoCo I used both many times and they work well just make sure that you set up the proper clearances. Jim www.performancejet.com

[sanger mike]

hey fomoco. I run the aggressor A bronze impeller with the leagend stainless wear ring and im happy with it. i ran out side and took this pic for you while my bowl is down at mpd. [img]http://www.***boat.net/image_center/data/506/115impeller-med.JPG[/img]

[Taylorman]

What would you say is the proper clearances? Also, I am about to buy a new wear ring for my aggressor impeller. After I measure the impeller, how do i know what size wear ring to buy?

[MAXIMUS]

FoMoCo:
Does anyone run Aggressor Bronze Impellers? I just bought a Aggressor B bronze and I was curous what RPM you guys are runnin with them? Also is anyone runnin the Ulitmate Wear ring with them? Any luck with this Combo? FOMOCO I have run a "B" magbronze agressor at 7000 rpm. I am goin to call dave next week to see about getting a double A for cruising & economy...
[ February 28, 2003, 10:27 AM: Message edited by: MAXIMUS ]

[FoMoCo]

Thanks Sanger Mike for the pics. looks like the one I just got!
MAXIMUS: What Kind of Horsepower are you runnin and what jind of hull? I am shootin for 600 HP and hoping to turn the Aggressor B to around 5600 rpms or a little higher!

[wideopen545]

iam running a Aggressor Bronze Impeller a cut with a blown bbc and turning it 6500 rpm in a youngblood 19 ft picklefork works fine

[jim@pj]

FoMoCo... Your Aggressor impeller will have a wear ring dia. of 7.225. A standard wear ring should be 7.250 in the case. That will give you an overall radial clearance of .025, which is good. You may have to install the impeller with shims to get your axial clearance properly set, don't go any tighter than .025. If your impeller is worn you may have to go oversize on the wear ring. Next size over will be 7.245 or .005 over. Jim www.performancejet.com

[ChetCapoli]

All this bronze impeller talk is making me want to go get some baby shoes....
Hey fomoco, i'm running an aluminum aggressor impeller with the ulitmate wear ring 5500rpm/700hp. As far as good luck...not the way HBjet looks at it.
CHET
[ February 28, 2003, 07:13 PM: Message edited by: ChetCapoli ]

[jweeks123]

iam running a Aggressor Bronze Impeller a cut with a blown bbc and turning it 6500 rpm in a youngblood 19 ft picklefork works fine
wideopen454, how much power does your motor make at 6500?
got any pix of a yb19 pickle?
jw