Here's a handy web site for someone building a stroker motor. http://www.smokemup.com/auto_math/index.php
I have a 427 tall block that I am going to build. Does anyone have any setups that they recomend. I wan to stroke it and bore it out. What are the limits to which I can take this motor? I also want to run a tunnel ram I am going to try to make soemwhere in the 800-850hp range. Any help or suggestions would be appreciated.
c19
Here's a handy web site for someone building a stroker motor. http://www.smokemup.com/auto_math/index.php
Ok maybe the hp range was a little high, but does anyone have any suggestions on what to do. i have read about these on the boards a little. I just am kinda new a need some advice.
c19
I just had my 427 tall deck built. put new eagle 4.25 stroke bored 60 over. new ross racing pistons 13.1.. new eagle h beam rods block had to be ground for clearance for the stroke its not cheap to build a motor like that.. its 496 ci new cam and springs and retainers runs great lots more power but it was my motor and heads still cost me 8000.00... big ones... if your interested i will sell it .....craig
How much hp did you make? and what about torque? How much do you want for it? What kind of setup is it? Heads, carb, intake?
c19
c19.... dont no the hp for shure desktop dyno 826 hp ....heads are dart 360. dart tunnel ram.. 2 x 1050 dominator carbs. 748 lift roller cam all new comp cam and springs..isky roller lifters.. I will take 8500.00 I got more than that in it.. to build this motor would be around 13000.00 bucks.. I have the invoice. I will email to you if you want it tells every thing that was done it pushes my 19 ft picklefork 98mph and with more fine tuning should be 100+ craig
Check these guys out for stroker info and parts www.speedomotive.com (http://www.speedomotive.com)
just get a tunnel made for a tall block i just changed gaskets from a leak what a pain in da but--nasty
cbreeze,
you've got mail
c19 didnt get your e mail try my new one lcraigluedeman@msn.com thanx craig