Reply With QuoteBetter luck to ya this time! I'll be down your way on Friday to dyno and tune at Larry's. Hopefully both of our second efforts will be better this year!
-brian
After wiping out my crank bearings and trashing the crank on the motor I built over the winter. Its time to start the another rebuild. I'm building a 40 over 454 short block and swapping over the heads and valve train.
Ready to get back on the water.
KC
Better luck to ya this time! I'll be down your way on Friday to dyno and tune at Larry's. Hopefully both of our second efforts will be better this year!
-brian
DogHouse:
Better luck to ya this time! I'll be down your way on Friday to dyno and tune at Larry's. Hopefully both of our second efforts will be better this year!
-brian I'll drink to that, maybe I'll swing by when your at Larry's.
KC
Cool, I'll be there all day. Probably take a few hours to set up in the morning and then do some tuning in the afternoon. Hopefully we'll finish but if not we might spill over into Sat morning. See ya...
-brian
Sorry to hear about your mill KC. Didn't know. I was on vacation for awhile. Did you figure a cause? Best of luck.
Peace Man
CESAR
What knid of .040 over pistons are you using?
Ceaser, its all part of the game, no big deal just time consuming.
Moneypitt, I have no idea what pistons they are, they came with the used motor(in pieces) I bought from a machine shop.
Doghouse, good luck and I'll try to swing by.
KC
[ July 10, 2003, 10:40 AM: Message edited by: AZKC ]
Good luck Kc. I know how that feels! I had to do it twice this year as well eek!
396
396_WAYS_TO_SPIT:
Good luck Kc. I know how that feels! I had to do it twice this year as well eek!
396 Thanks 396 maybe some luck would help smile_sp
KC
Posting Permissions