How thick its that aluminum
heres a pic of the plates and rails, one plate has the anodizing partially removed, they came out of a 19ft. daytona and they were made by harold bruce of r&d marine. [img]http://www.***boat.com/image_center/data/521/409Dcp00488-med.jpg[/img] heres why i am not going to be using these plates [img]http://www.***boat.com/image_center/data/521/409Dcp00485-med.jpg[/img] let me know if you need dimensions or more info. sorry i took so long, i had to rig up a battery pack for my camera.
How thick its that aluminum
3/8 in both photos
cs19 they look like i could cut them down width
wise e-mail me with how much you would like to get for them. have you had a chance to get by your dads place to take a pic of the splash on
the southwind ? thanks pat(slotracer)
I like that setup on the bottom pic. Very nice.