Reply With QuoteI WISH YOU WERE LITTLE CLOSER THAN I WOULD HAVE TO GET IT FROM YA
LATER
PROMOD
FOR SALE! $7,000 PM ME for the number.
Just put over $9,000 into the motor and powdercoating. About 2 hours on the new engine.
468 10.5:1, full roller, big valves, lots of headwork. Estimated 750 HP.
You will need to have the pump rebuilt. It works right now, but the engine is too powerful for the pump. I have a stainless steel impellor that needs to have about $200 bucks worth of work to it, then you can use that.
You will also need a tack for a Vertex Mag. I have AutoMeter gauges in it right now.
Great engine, Nice boat. I'm just not going to put any more money out on this thing!!!
Come and Get It
http://www.***boat.com/image_center/...080006-med.JPG
http://www.***boat.com/image_center/...080009-med.JPG
http://www.***boat.com/image_center/...080015-med.JPG
http://www.***boat.com/image_center/...2small-med.jpg
I WISH YOU WERE LITTLE CLOSER THAN I WOULD HAVE TO GET IT FROM YA
LATER
PROMOD
PC,
How long have you owned this boat?
What color was it before it was repainted and do you have any picture of it prior to repaint (this is important)?
Was any bottom work done to the hull?
What is the production year of the boat (last 2 numbers of the hull ID)?
What kind of lay-up do you think the hull is?
What kind of pump and internals?
Jet-a-way?
Any work ever been done to the hull (repairs; setback, etc.)?
How fast have you GPS'sd this boat?
LO
I've owned the boat since March.
I beleive the white base is gel with the graphics sprayed over it.
I donj't know of any work done to the bottom.
The layup was kind of light I think, but the previous owner had just had the entire floor, sides and transom strengthened or reglassed. The floor is Parquet and the stringers and everything else were new, I had to drill all the holes new for the plates and everything else.
The pump is a Berkeley slpit bowl etc. It has a peice of shit aluminum impellar that is ate up pretty bad. I do have a stainless steel impellar you can have though. It needs to have about 200 bucks worth of work done to it according to MPD.(turned down)
No jetaway and no repairs that I know of.
I haven't gps'd it, but seemed to be going about 75. Like I said, the motor was just spinning the shit out of this pump and was not very efficient! Pump will need new wear ring and put that stainless impellar in it.
Here is a pic of the CF's
http://www.***boat.com/image_center/...080014-med.JPG
Nice ride........
So what are you afraid the Bigproppa (aka pickfork1) is going to kickyour ass this summer and you feel it's best to just right in a realy fast boat, than to try and compete with a want a be boat.
Nice Ride sorry to see you want to sell it alread....what's up with that...
Mark
Would you be interested in selling less motor?
WTF??? you dont really want to sell it do you? come on Rob you finally have a complete boat
Did that boat used to belong to Scott of Advantage in Riverside off the 91 freeway?
Pipes Cleaned I have a buyer for your boat. Please hold me in 1st position. Check your private messages. BRD
Posting Permissions