RD, what's the overall dimension of both of them. I like both of them and just need to see the sizes. I'm good for one and like the big one and just don't know if it will fit where I'd like to put it.
RD, what's the overall dimension of both of them. I like both of them and just need to see the sizes. I'm good for one and like the big one and just don't know if it will fit where I'd like to put it.
Are you gonna make them for Clarion also?
http://www.clarion.com.au/Marine/pro.../m301rc_th.jpg
Originally posted by RiverDave
The overall dimensions are as follows.
The Access Technologies Unit is
4.480 x 2.240
The smaller bezel is
4.700 x 2.460
The bigger bezel is
5.100 x 2.860
So figure on the bigger one it's about 3/10ths of an inch per side. The smaller one is just over 1/10th of an inch per side.
RD
Thanks Dave. As soon as I see if it fits the new boat I'll be in contact. So what kinda of pricing you looking at.
Dave,
Can you trim the bottom out so it is only a bezel and not the cup design...I just want to mount with double sided tape or some adhesive...I don't want to pull the console to get to it?
I will check the measurements this weekend, but I am down for one...
Originally posted by jbtrailerjim
Are you gonna make them for Clarion also?
http://www.clarion.com.au/Marine/pro.../m301rc_th.jpg
so how do you like your XMD3 ?
Originally posted by ROZ
so how do you like your XMD3 ?
Not sure yet. The install should be complete this week. I'm mounting one on the dash and one on the transom.
Originally posted by mbrown2
Dave,
Can you trim the bottom out so it is only a bezel and not the cup design...I just want to mount with double sided tape or some adhesive...I don't want to pull the console to get to it?
I will check the measurements this weekend, but I am down for one...
Come on do it right pull it all apart
Will this controller work with a Pioneer deck?
Dave, Those bezels look trick.
Originally posted by RiverDave
I can do whatever ya want Mike.. Just don't ask me for a flag pole receptacle and all will be fine. Personally though, I think double sided tape is cheezy, and I'll go on record right here saying that. I could understand if you owned some bailin wire / duct taped up jetboat.. But a DCB?? You'd think you could atleast find a way to zip tie it on. So you don't have any access to the 2 nuts that are holding your control on there? Becuase all you have to do is unscrew them and then screw em right back on?
RD
Yeah....you and BF are right...I should do it right...I want one pewter anodized....I figure out how to get it on there or have someone install...taking the console out will be a job through...