Finally completed the 3 1/2 gallon bullet fuel tank. Made of carbon and in one piece. There are no seams in the tanks construction. Only those seams on the surface where the molds break apart. There are 4 tabs on the sides to hold the 8 inch brackets for mounting. The fittings are -8 and -12, with a flip top fuel fill. Other sizes can be used as well as a -16 on the bottom. I'm pretty proud of this piece since it requires double molds. One for RTM and the other to create the id investment casting. Everything on the inside comes out the 1 1/2 inch hole to leave the tank with a 1/8 inch wall thickness.(my little secret
)
What a pain and $$ to make, but here is a picture. Let me know what you think..?
http://www.***boat.com/image_center/...050142-med.JPG
Not sure why I put it on the black tile for a picture, should nave used the white one.