Tunnel ram to blower manifold

[Blown 472]

anyone ever built one or know of it?

[78Eliminator]

Yeah, there is a sheet metal manufacturer that makes them. Let me get the name, hold on... VERY pricey CG!!!

[Blown 472]

Originally posted by 78Eliminator
Yeah, there is a sheet metal manufacturer that makes them. Let me get the name, hold on... VERY pricey CG!!!
I want to cut one apart and build it myself.

[78Eliminator]

Oh, so you are looking for someone that has done it. Ok. That sounds like some work!
Definately better than shelling out 3k on a manifold.

[Blown 472]

Originally posted by 78Eliminator
Oh, so you are looking for someone that has done it. Ok. That sounds like some work!
Definately better than shelling out 3k on a manifold.
Yup, I am looking to build a blown small block mopar and the blower manifold they sell is a piece of shit, so I am thinking of cutting a tunnel ram, building a plenum with a tented floor and make it so I can put my other blower on it and stuff this motor into a dakota.

[full throttle]

I just picked up a tunnel-ram blower intake for my new BBC. The guy said it was a blue thunder intake, but I can't find anything on it. Hope it looks as good in person. I'll post some pics when I get it (any day)

[Fiat48]

That name is familiar. I think BAH 468 has one on his deal. Really nice piece.

[BAH468]

I'll look forward to seeing your pics. I can tell you after I see them if we have the same one.

[full throttle]

So whats the trick? Can't seem to get a pic posted.

[paradigm shift]

I don’t' have good pictures of the floor but I have an old street blower book that has some pictures in. Don Hampton and others used to make manifolds this way in the past before custome castings became cost effective. I really do not think it would be too hard. They even did it with low manifolds.