Im looking to go to a set of roller rockers. I am now running stock stamped steel non adjustable rocker arms and have no experience on how roller rockers are set up. I have a couple of questions on setting up to achieve correct geometry. From reading a couple of articles on the web this is how I see it. Tell me if this is right.
For stud mounted roller rockers, they use guide plates which hold them inline with the pushrod and valve tip and prevent them from rotating off the valve right?
The nut is used to adjust the height of the rocker on the stud which gives you correct geometry in relation to the valve tip and requires an adjustable pushrod to figure out the correct length pushrod needed?
Is this correct so far?