Polish it where the bowl bearings ride, replace the bowl bearings and you are good to go. If the wear was severe, there is a repair sleeve for the bowl end of the shaft, we do these all of the time. No problem. TIMINATOR
I have a Dominator 12 S pump.The shaft has .001 run out in the center when clamped in a lathe and checked with a dial indicator.Also where the bowl bushings ride it is worn to 1.120 from 1.122.Is this shaft servicable like this or will it need repair?Thanks for any help. Mike
Polish it where the bowl bearings ride, replace the bowl bearings and you are good to go. If the wear was severe, there is a repair sleeve for the bowl end of the shaft, we do these all of the time. No problem. TIMINATOR
tim is on the money Thats what I would do
396
Thanks guys!I already polished the shaft when it was in the lathe.I just need to order the parts to put the pump back together. Mike