cut for set back (notice almost 1.5" off added fiberglass in the bilge area)
i had a few inquires as the progress on my project.
I turned the boat back over removed the intake had it machined for a shoe and rideplate. reinstalled the intake (setback 3"). flipped the boat agian and have recently finished removing the hook up to 1/2" in the worst spots.
I have also finished the trailer below are a few pics. Pending rain i hope to have the bottom in paint by tuesday.
This sure has been alot of work I hope it was worth it.
bottom before
cut for set back (notice almost 1.5" off added fiberglass in the bilge area)
intake reinstalled and boat back over
ground down rear of the boat to properly line up with the intake. The intake is now set in at 4 degress the old setup was almost 10.
first round of primer. it's since been guide coated and blocked to make sure it's straight.
and now the trailer before
another
and after i know have the fenders back from chrome and diamond plate steps but no pics yet
last one. sorry i coulndn't figure out how to get this in 1 post.
Man you are really making some progress.I do not see how you could go wrong with strighting the bottom and adding a shoe and ride plate.
Is the boat going to be light blue too?
Jake