Reply With Quotehere is another pic of the acrylic before cutting
Ive read some trheads on this before and since I was attempting to making this thing myself, I thought Ide share my adventure.
I made this splash for less than 40 bux. I used my buddies single stage cooker to heat the 1/4" acrylic then formed it to the rear of my Jet boat. I just may make it to the lake.
This is my second try at it. 3/8" was hard to heat up and bend so I tried 1/4" and it was cake! I cracked this on while cutting it. I was in a hurry again. I still have a chunk left to make a new one if I have to.
It wasnt so hard once I clamped the splash to the rear of the jetboat it all came along. here are some pics if it works
here is another pic of the acrylic before cutting
back end view. I raised it up from the original by an inch
Last one of the burner
Now does anyone know where I can get that beaded fabric or gasket material to finish it off???
Looks good man!
Nothin like doin it yourself plus savin some$$$$$$$$ for beer money. I'd think any upholstery shop could give you the beaded material. I think it's called "pipeing" not sure on the spelling.
Peace Man!
CESAR
thanks Sidewound, I'll check one out thats local.
I helped drink the beer so I was even a bit less expensive
Posting Permissions