Page 1 of 2 12 LastLast
Results 1 to 10 of 11

Thread: 73' Hallet Bubble Deck

  1. #1
    MudPumper
    Who has info on this boat, performance capabilities and what not??

  2. #2
    Squirtin Thunder
    Check out Jacks site MPD under suported boats.
    Hallet hath no furry or something like that.
    Jim

  3. #3
    Nubbs
    Originally posted by MudPumper
    Who has info on this boat, performance capabilities and what not??
    Are you looking to get another boat???

  4. #4
    MudPumper
    I'm always looking for a good deal, ran into a guy who has a 73 19' Bubble deck in pristine condition, origional owner, new trailer, interior, cables etc...... The only prob is it has a 455 and a Jacuzi pump.:frown: I don't know if it would be worth the time and money to swap pumps and motors.

  5. #5
    Hustler
    If you plan on making it run hard your going to need to change the pump.
    The Hallet that Squirtin Thunder is talking about is Tom Bandy's 19'. I beleive it's running about 96mph or so in the quarter but Jack and Dave both have alot of time into that boat

  6. #6
    MudPumper
    Yeah, Ive seen Bandy's boat run, it's bad ass a total sleaper. If this boat didn't have the Jacuzi it would be a done deal because I have a BBC to replace the 455. I just don't know if it would be worth the cost of switching pumps. ????? It would be a great boat though. And it's clean as hell, some old guy has had it since new and taken great care of it.

  7. #7
    Hustler
    The glass work probably would'nt be that bad, and I know BigBoysToys had a whole JG pump for sale last week. It just depends on how much you want to put into it

  8. #8
    MudPumper
    Originally posted by Hustler
    It just depends on how much you want to put into it
    Yep, just like everything else in life. Swapping the pump and changing out the motor would be all this boat would require. Other than a few cracks in the gel on the deck, the boat looks brand new. I couldn't believe it was a 73'. I'll have to call Jack and see what it would run to change out the pump.

  9. #9
    Hustler
    Call Todd @ TRG for the glass work he can give you an idea of what it would cost, Jack will only cut the hole and set the intake.
    Todd's number is 626-991-9031

  10. #10
    MudPumper
    Great, thanks Joe I'll give him a call and see whats up.

Page 1 of 2 12 LastLast

Similar Threads

  1. hallet 260 deck boat
    By go chiefs in forum Cats & Tunnels
    Replies: 14
    Last Post: 06-16-2007, 05:36 PM
  2. 19 Ft Bubble Deck
    By 460 WJ in forum Jet Boats
    Replies: 6
    Last Post: 05-24-2005, 03:58 PM
  3. E-Bay Bubble Deck
    By Boatmike in forum V-Drives
    Replies: 7
    Last Post: 07-29-2004, 04:28 PM
  4. Tom Bandy's Hallet Bubble at Ming
    By HotHallet in forum Jet Boats
    Replies: 16
    Last Post: 12-09-2003, 10:47 PM
  5. 19' Hallet bubble deck jet at Ming
    By bigriverdog in forum Jet Boats
    Replies: 14
    Last Post: 11-18-2003, 08:23 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •