Ouch!
My guess is that the imbalance wouldn't do your thrust bearing, crank bearings, etc any favors. Can you feel any extra vibration when running it now?
Did something dumb and sucked up a rock and got this chunk out of the impeller.
Due to time contraints I probably will have to leave it like this for a while, Can I still run this impeller without further damaging the pump? We pulled the rock out and did run it back to the dock and there was no noise or anything, but I felt like it was not pulling as hard as before the rock.
http://www.classicglastron.com/messa..._Handhole1.jpg
http://www.classicglastron.com/messa...ellerchip1.jpg
Ouch!
My guess is that the imbalance wouldn't do your thrust bearing, crank bearings, etc any favors. Can you feel any extra vibration when running it now?
Ouch!
My guess is that the imbalance wouldn't do your thrust bearing, crank bearings, etc any favors. Can you feel any extra vibration when running it now?
Nothing significant. I assume that this impeller could be repaired is that right?
Chris (CS19) could probably answer that question for ya. I don't know personally. I've picked up rocks before, but they only resulted in little dings/knicks. Nothing like what you've got there.
If you can't feel it I'd run it.
Or you could knock a similar sized piece off the opposite blade to make it match.
Watch your RPMs. You might find that it caviatates and lets your motor rev higher. You dont want to over-rev.
I am gonna go try it now, This is a 20 foot glastron CVX so I don't really hod rod it, nothing much above 4000 for me. Just tow the kiddies around the river.
You sure those aren't teeth marks in there??? LOL
From the pics it looks like aluminum? If so, yes it can be repaired.
I'm sure that you can definatly feel that it doesn't pull as hard-that's a good sized chunk.
I would suggest that you send it to Duane or Jack for repair as the angles ground on there are pretty critical. Or possibly one of the two would just send you anothre used one in good shape...
Ken F
It is already cavitating - You can see the burn mark already.
i have a american turbine A-2 alum alloy not tinsloy
new condition size std/std on the ring side 225.00 i pay shipping
tim 540.871.4833