I make 800 hp and run 9.20 in a 470# jet boat.VOODOO,do I know you? I own Performance Marine down on Lake Whitney(Kopperl).Give me call sometime.It's in the phone book.
Garry
wsuwrhr:
I make parts to put a wedge in a boat. The right motor mount(the "flat" side) would be a little harder to make but not impossible.
BrianI assume you are talking about the flat machined part of the block where the automotive motor mounts bolt to. Unfortunately, a lot of the Hemi blocks don't have that and there are not a lot of large bolts (7/16" like Chevy) on the front part of the engine. Some guys like to use two separtate plates the go up to the old water pump in/outlets, but I prefer a single plate. I think it adds a little more strength.