Big Block Ford stuff

[ssmike]

I have some used parts.....
Torker 460 manifold with carb spacer (pic below...)
http://www.***boat.com/image_center/...41IMG_0552.JPG
Mallory Distributor with 9.5 mm MSD plug wires:
http://www.***boat.com/image_center/...41IMG_0561.JPG
Hardin Marine timing chain cover:
http://www.***boat.com/image_center/...41IMG_0554.JPG
http://www.***boat.com/image_center/...41IMG_0553.JPG
I was thinking that somewhere around $175- was fair for the whole deal...I will ship FEDex ground - on the west coast-Az. etc., its very reasonable and will probably be less than $10
Or, if someone wants me to part it out, PM me.
I also have some other parts that I will post in the thread.

[Ralph Brunt]

interested in all but the manifold sent u a pm thanx ralph

[RUSSO]

How Much For The Intake..

[dmontzsta]

I have a rusty timing cover that block off plate can mate to.

[ssmike]

Is anyone interested in this stuff before I list on Ebay?

[Schiada Time]

Ah. My old big block Ford parts. Mike what did you end up doing with that motor?
Hot Rod Hallett

[ssmike]

I was wondering what happened to you......I had not seen any recent posts by you.
Here is the motor:
http://www.hotboatpics.com/pics/data/500/5187rc6.jpg http://www.hotboatpics.com/pics/data/500/5187rc8.jpg http://www.hotboatpics.com/pics/data/500/5187rc7.jpg
Almost done.

[ssmike]

anyone? LOL.

[RUSSO]

Do You Use A Box For The Mallory??or Stock Set Up Or Just A Coil??i Am Intrested If My Truck..later In The Week If You Still Have It Mayb I Can Swing By And Meet You Some Place..i Drive All Over For Work..so We Can Prob Work Something Out..

[ssmike]

Russo:
Just a coil, I think.... with that Mallory.
Anyone else interested???