Results 1 to 4 of 4

Thread: Rubber Bellows on cables?????

  1. #1
    Wonder if the rear two rubber bellows that are attached to the end of the steering and gate cables are suppose to be water tight? I found a couple of small holes in mine and was wondering if the holes could allow water to enter the boat. If I need new ones, where could I find them?

  2. #2
    Think most boat supply companies sell them and I would replace them if they have holes in them.

  3. #3
    I think replaces them no matter what, but if there are holes in the bellows does that allow water to enter the boat?

  4. #4
    502 JET
    If they have holes and they get submerged water will leak into the boat.

Similar Threads

  1. Mercuiser Bellows replacement???
    By DansBlown73Nordic in forum Sandbar
    Replies: 2
    Last Post: 07-22-2007, 02:24 AM
  2. Help replacing shift cable bellows
    By curtis73 in forum Gear Heads
    Replies: 7
    Last Post: 07-08-2007, 11:21 AM
  3. Which exhaust bellows?
    By curtis73 in forum Gear Heads
    Replies: 2
    Last Post: 04-11-2007, 09:33 PM
  4. rubber bellows
    By checkr'd past in forum Out Drive
    Replies: 3
    Last Post: 07-24-2006, 07:04 PM
  5. Wow, no exhaust bellows=800rpm increase
    By TahitiSteve in forum Out Drive
    Replies: 4
    Last Post: 08-13-2003, 11:08 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts