- Please Help (13 replies)
- A little vid (7 replies)
- header inserts wanted (1 replies)
- Brad Penn Oil (3 replies)
- Parker?? (28 replies)
- "Hard Times" ?? (10 replies)
- Oil in the boat....not in the motor... (23 replies)
- Drake Pump Parts (12 replies)
- Since the engine is out... (9 replies)
- What's up with Mudpumper? (3 replies)
- Need A New Steering Cable Tube (6 replies)
- What's the trick in unbolting the D.S from the flywheel? (9 replies)
- 8 weeks later, and a hole in the water full of money (my first boat restoration) (19 replies)
- Blythe Picks 5-12 (21 replies)
- Weekend At The Avi ! (127 replies)
- blower shop blower (1 replies)
- APBA Propeller mag (9 replies)
- Best 21 tunnel out there (11 replies)
- Which drill bit should I use? (8 replies)
- Almost Ready (12 replies)
- exhaust tip replacement ? (7 replies)
- Need some help! (7 replies)
- a question about stringers (9 replies)
- Finally Hit The Water But! (20 replies)
- Pump (1 replies)
- test run (7 replies)
- Rideplate angle (7 replies)
- Tapered shoe (5 replies)
- Mothers day (0 replies)
- First trip out (12 replies)
- Yuma Power Tour Next Weekend!!!! (24 replies)
- when next long beach swap meet (2 replies)
- set back berk question (19 replies)
- Too Loud! Fix-it Ticket! Help...? (21 replies)
- ford, front motor plate (5 replies)
- BrendellaJet (0 replies)
- Loose bow eye (23 replies)
- my boat for sale :( (2 replies)
- oil brand (1 replies)
- Name my Cole for me (76 replies)
- Top mount starter for sell???? (4 replies)
- Cover for blower finished! (14 replies)
- Steering Q (8 replies)
- Hondo T-deck/ Cole T-deck rear seats (12 replies)
- Who is the owner of this boat? (12 replies)
- Just bought, Anyone near Redding? (37 replies)
- Race Prep'd Jet Pump Anyone? (0 replies)
- 6th street (15 replies)
- Cable Packers (1 replies)
- Stainless steel tube (14 replies)
- Log/Riser Sealant (1 replies)
- Jet Insurance and V-drives (46 replies)
- 75 Tahiti Update Pics (14 replies)
- ski tow and rack (2 replies)
- Big River Warm Up (24 replies)
- lost 6-8 mph with jetovator (42 replies)
- need some cross refrence starter help (0 replies)
- NJBA May Shootout Pics???? (67 replies)
- 1979 Glastron CVX20 (0 replies)
- Boat Parts (3 replies)
- ? about the Windage tray (8 replies)
- intake to suction housing alignment (7 replies)
- Headers & Horse Power (9 replies)
- Lean condition with the Sanger (6 replies)
- hiding (4 replies)
- no spark (10 replies)
- Console help......anyone? (0 replies)
- water injection (13 replies)
- Pressure Regulator (94 replies)
- Paging Old Rigger (5 replies)
- Looking for a clean jet (12 replies)
- covered or not covered (12 replies)
- A Few Cheyenne Progress Pics! (67 replies)
- Help! (1 replies)
- high backs and center console (10 replies)
- Holley 800 carb & Torker intake (2 replies)
- Some help PLEASE!!!!! (3 replies)
- Adding a gas tank sender? (10 replies)
- Difference In Jets? (4 replies)
- 455 Alternater Pics (4 replies)
- 18' Spectra.....lets see pics of yours (22 replies)
- Best place to order a bimini top? (10 replies)
- Jet boat parts catalog....where or who? (7 replies)
- Why no synthetic (14 replies)
- Boat Cover - $$$$$$$$$$ (15 replies)
- looks like the trim works... (3 replies)
- Jetovator Motor Delco Replacement???? (6 replies)
- sealing transom plates (4 replies)
- Looking For Jet Boat Mechanic (7 replies)
- Trying to get back out on the water... (8 replies)
- Bennett bottom work (1 replies)
- Duane HTP (13 replies)
- Looking for a Manual Place Diverter - Nozzle Assy Only (3 replies)
- What Can Blower Carbs do... (3 replies)
- How do I replace the bow eye? (46 replies)
- Dual 450'S Part Dux (13 replies)
- Good Deal on a Bahner! (1 replies)
- found some pics of project so far (0 replies)
- The moment of truth... (9 replies)
- Air/fuel mixture on a Rochester Quadrajet carburetor? (7 replies)
- high speed vibration (11 replies)
- need round cover (0 replies)
- Lookin for a Jet near NJ (0 replies)
- I need a place diverter (0 replies)
- trailer brakes (1 replies)
- Steering (3 replies)
- Ming Race Reports? (59 replies)
- stoker (1 replies)
- shortening headers (19 replies)
- look at this jet drive (2 replies)
- Steering Cable Hookup? (11 replies)
- Need a packing gland for a Berkeley 12JC (1 replies)
- I Need A Place Diverter Controller!! (10 replies)
- Look what I got for the Sanger. (8 replies)
- Oh Taylorman .... (0 replies)
- Ming Races this Weekend - Local Writeup (1 replies)
- Clocked @ 88mph and now 100mph (40 replies)
- Question for the pro's... (4 replies)
- New Upholstery Pics! (11 replies)
- reverse throttle & diverter adjustment help (3 replies)
- the river (5 replies)
- Power Valve Question (13 replies)
- HELP help with moter removal (6 replies)
- Oil temp sender instal (12 replies)
- East Coast Jet Boat Shops (4 replies)
- Parker this weekend (19 replies)
- Since I re-registered and all (5 replies)
- Apache Jet Boats - McManus? (12 replies)
- lost the original manual (5 replies)
- Engine alignment and stringer Q's (7 replies)
- New U-Joints? (7 replies)
- Anyone got an extra Olds? (1 replies)
- Removing silicone ??!!! (7 replies)
- power tour may 18-19-20 (16 replies)
- 455 Flooding issue (12 replies)
- Alternator muunt (10 replies)
- new seats. (8 replies)
- Boat Progress (4 replies)
- 1"vs 2" stringers (20 replies)
- Cooling System help (6 replies)
- trim tabs on a jet..good or bad?? (15 replies)
- Flame arrestors? (3 replies)
- Transport from Oregon to California (38 replies)
- 4 days till Ming...drags (26 replies)
- Marine Power 454 Solenoid Question (13 replies)
- Impeller/bowl help (11 replies)
- Header Coating Burning Up - Help (19 replies)
- Electrical questions (14 replies)
- Which driveshaft!?!?!? (3 replies)
- Simple engine questions about a bbc 396 (7 replies)
- hey Holley carb Gurus (5 replies)
- major gel coat cracking...what do you do?? (40 replies)
- Remote Breathers (19 replies)
- Headers Wanted (7 replies)
- 19' Eliminator Daytona For Sale on EBAY (11 replies)
- need help locating hydraulic diverter ram... (3 replies)
- Cutting tubing pipe length wise..trick (3 replies)
- Help (0 replies)
- Wanted - pics of JR Custom jets by Sonic (0 replies)
- Floor questions (16 replies)
- Starter issues (9 replies)
- Thank You High Flow Dynamics! (11 replies)
- Another engine thread (2 replies)
- FourQ (1 replies)
- Park Moabi Trip Pictures (17 replies)
- Lets see some 21' cruisers (74 replies)
- Distributor Paint Question (0 replies)
- Distributor Paint Question (0 replies)
- School me on steering wheels (12 replies)
- the wait is killing me (9 replies)
- couple questions (5 replies)
- Opinions of Spectra's (27 replies)
- Midweek at Blythe 4/25 - 4/26 (14 replies)
- Tin can boats (161 replies)
- My upgraded ride! (13 replies)
- Driveline issue solved (9 replies)
- This is good for a laugh (14 replies)
- Calculated Horsepower? (6 replies)
- valve adjust (21 replies)
- Paging Mudpumper (2 replies)
- Clearancing Impeller (23 replies)
- Golan Fuel Valve (4 replies)
- Foot Throttle question (8 replies)
- Small block or Big block (99 replies)
- First trip of the season (1 replies)
- Pumps: Different model Berkeley's (4 replies)
- Saturday Saturday Saturday! (8 replies)
- how can a person install two batteries on a boat? (1 replies)
- Wireing (2 replies)
- Ride plate and shoe question (43 replies)
- OLDS 455 New Build Problems (32 replies)
- hey phx ***boaters (8 replies)
- R&D Marine ? (54 replies)
- radar guns (2 replies)
- jet boat cover (1 replies)
- seen on craigs list...90+ (5 replies)
- New respect for painters!!!!! (19 replies)
- Boat cover (3 replies)
- Yet another 100 mph EBay jet boat!! (28 replies)
- Super Jet (21 replies)
- removing an old 12jb pump (6 replies)
- Replacing Holly Carbs for Demons (27 replies)
- Cole 440 coming out if you remember this ride.. (51 replies)
- 78 marlin water ready (10 replies)
- Name help for the cheyenne?? (36 replies)
- NJBA @ Bakersfield May 5, 2007 (48 replies)
- my new ride (24 replies)
- Jetaway, diverter and droop snoot! (5 replies)
- interior changes for the cheyenne (10 replies)
- 2007 River of No Return: 361 days and counting (0 replies)
- Parker Circles Jet pics (20 replies)
- Thanks Brian Busby (53 replies)
- I'm now one of you guys (11 replies)
- Need some HELP..... (10 replies)
- Gotta Get It Done (1 replies)
- FOURQ and Nucknfuts (22 replies)
- Thanks You Guys (18 replies)
- Thanks You Guys (4 replies)
- race results? (24 replies)
- 455 or 454 (44 replies)
- boneyard (31 replies)
- The Stevens got wet saturday (2 replies)
- How many, and what type of fuel filters do you run? (9 replies)
- 427 or 454 bbc in a jet boat?? (9 replies)
- What else do i need? (5 replies)
- brand new 460 12je pump and new 'A' impeller something wrong??? (15 replies)
- Power Tour 9 in needles (pics) (28 replies)
- And yet another parts at home (2 replies)
- Sticky throtle pedal...Im dumb (3 replies)
- A question about stringers and floors! (6 replies)
- Another Making Parts at home..pics (1 replies)
- Just put the new gas tank in. (7 replies)
- need 454 mounts (8 replies)
- Need Panther Help (2 replies)
- Saturday at the Avi Pics (26 replies)
- project 75 tahiti resurection (28 replies)
- Driveline guys, please read........ (41 replies)
- It Lives!!!! (2 replies)
- axle's? (4 replies)
- American Turbine Impeller help (4 replies)
- Help with BBC mechanical fuel pump (15 replies)
- need of a 454 .030 block baddly!!!! (2 replies)
- Carburetor work (3 replies)
- I am looking for a oil pan !!!! (6 replies)
- Yes you CAN make parts at home (28 replies)
- Intake Pressure Part II (49 replies)
- Lets talk cruising speeds.. (20 replies)
- Banderlog Wanted (8 replies)
- Safety (6 replies)
- What could of caused this??? (7 replies)